High Lifter Can-Am Defender Riser Snorkel Kit (2020-21)

The High Lifter Riser Snorkel Kit for 2020-2021 Can-Am Defender Models. High Lifter makes the highest quality and most comprehensive snorkel kits in the ATV/UTV industry. This High Lifter Snorkel kit contains everything you need to properly snorkel your ride. Custom Powder Coated Riser Bracket to keep risers straight, evenly spaced and looking good. 

Store Wide Sale! Save 5% to 15% at Checkout on 1000's of products. 

There are no returns or refunds on any brand of snorkel - All Sales Final.

Fits:
2020-21 Defender HD10 DPS
2020-21 Defender HD10 XT
2020 Defender HD10 XTP
2020-21 Defender HD8
2020-21 Defender HD8 DPS
2020-21 Defender HD8 XT
2020-21 Defender MAX HD10 DPS
2020-21 Defender MAX HD10 XT
2021 Defender MAX HD8
2021 Defender MAX HD8 DPS
2021 Defender MAX HD8 XT

Note: Does not work on CAB models or units with a Back Glass Window.

Note: You have to cut/trim some plastic to install this kit.

Click Here to View the Spark Arrestor Advisory

Features:
Rubber Grommets to hold riser tubes in place
1 ½”, 2” or 3” Risers - based on specific model
Heavy Duty Vinyl Tubing to route difficult locations where the competition uses think tubing
High Heat Silicon Hose in those critical areas where the competition melts
Bellows to keep water out of differentials and transmission
All mounting hardware for complete installation
Step-by-step instructions complete with detailed photos

Benefits:
Provides clean, dry air to the engine and other parts needing venting.
Prevents mud, water and debris from entering the engine and clutch housings when equipped.
Bellows allow the differential and transmission air to expand and contract without the need for long vent lines that can easily get plugged with mud or be pulled off.
Each Kit is engineered and cut to fit your specific application.

Snorkels leak for a variety of reasons. Installation errors account for a lot these. Many times, a do-it-yourselfer may get it right, but only for a short time. When pipes aren’t cut to correct length and things don’t line up quite right, many times the snorkel will prevent water, but only for a limited time, then the joint fails. One of the most common that we’ve seen is failure due to a heat source. When the snorkel runs close to heat source the snorkel material deteriorates during each ride. The material gets harder and more brittle, and many times begins to deform. At some point the material cracks and begins to let mud and water in. Less expensive kits rarely provide the heat resistant material to account for this. Our goal is to avoid these areas. This can take more time and more material but goes a long way to extending the life of the snorkel and the ATV/UTV.